Leathercloth Flat EdgeTrim Folded like bias binding this flat leathercloth trim can be used under decorative upholstery nails to edge chairs. approximately 1/2" wide it comes in black, red, brown, green and beige. Please state colour in details box of shopping basket. Samples available on request.
Code HID/FLA- RL When ordering full roll please state colour in messgae box after basket
Code HID/FLAT-BLK- Black
Code HID/FLAT-BRWN - Brown
Code HID/FLAT-RD - Red
HID/FLAT-WHT - Off White

Lethercloth Trim Double Piped (Hidem Banding)
This is a very clever leathercloth trim used on all types of furniture and in car trimming. It can be fixed in place by hiding the staples or tacks between the two rows of piping. Available in black, red, brown, green or white. Please state colour in details box of shopping basket when ordering full roll.Samples available on request
Code HID/PIPRL to order roll please state colour required in notes on page after shopping basket
Code HID/PIP-BLK - Black
Code HID/PIP-BRWN - Brown
Code HID/PIP-RD - Red
Code HID/PIP-GRN - Green
Code HID/PIP-DSKN - Doe Skin
Code HID/PIP-WHT - White

Hide by Square foot
We carry a limited stock of hides that we will cut and supply to you by the square ft. colours are limited to green, brown, burgundy, black & chestnut. Please order samples - remember to specify colour in details section of shopping basket.
Code HIDE1 - Limited colours and finishes £11.22 sqr ft. charged to the nearest sqr inch - for example a 14 inch square piece would be charged as 1.36 sqr ft
If you are unsure about how you will need to buy your hide please email us with a rough idea of the size of pieces you need

Leather Skiver with Tooling
A skiver is the type of leather that is inset into a desk or bureaux writing surface, quite often with a gold tooling around the edge. It is normally made of a very fine type of leather often sheep or calves skin.
We can make you a skiver to order with inlaid tooling to a pattern of your choice. Please email for pattern leaflet and state the colour of the leather required so that we can send you actual samples.
Code HIDE/SK - sold by the sqr ft priced to the nearest sqr inch.
Please note there will be a small order charge of £4 added to all orders under 4 square feet and a minimum charge of 1.5 sqr ft for smaller sizes.

Leather (Hides)
The hides we supply are of the finest Italian leather. They are full grain leathers with fully penetrated dyes. Please order free samples using our 'Contact us' tab.remember to state colour required and type of finish, ie. smooth heavy grain etc.- You will be able to ask for a large or small hide and we will quote you our available sizes. Some half hides are also available.
The picture is a layout of a hide measuring approximately 48 sqr ft or 4.4592 sqr mtrs to assist you in your requirements. Remember that thinner pieces like belly and flank is not always suitable for seat areas.
Estimating your requirements:
A cowhide varies in size and can measure from 4.5 to 6 sqr metres or 48/60 sqr ft. You can request an approximate size when ordering.
As a guide one linear metre of 50/54" width of fabric equals approximately 18 square feet of leather.
The drop down box below will give you an idea of prices. These prices are per sqr metre. We can supply any colour and finish. Please request samples